Search results

Buz/hum is normal in all type of amps. Especially with single coil pickups.

Don't buy RG50TC. Why? First of all it has the worst clean channel I have ever heard. Oh sorry, it doesn't have any clean channel because it becomes crunch when You turn the clean level more then 10 o'clock... That means You can't play any clean sound at higher volumes! If You want to use some...

If You already own it, simply try how it works with your processors. If it will cause hum put it on ebay if not, leave it in rack :)

I would buy RH300 :)

I agree with Randall tech support, when You run your amp at 100% it generates frequencies that are destructive to your speakers. I have no idea how do describe it in english but Tim is right. You should use your cab at 100% not your amp.

Have You tried Randall Shop?

If You hear the difference then You are the one and only who can tell if they sound better or they don't :)

Jaguar is made by Eminence not Celestion, and its custom for Randall so there is no info about it on www.eminence.com. But You can always try contacting them [email protected].

Because this is CELSESTION loudspeaker the impedance is engraved on the speaker's chassis, propably its 8Ohms here is more info: General specifications Nominal diameter 12", 305mm Power Rating 75W Nominal impedance 8Ω and 16Ω Sensitivity 97dB Chassis type Pressed steel Voice coil diameter...

Thanks for any help :) There's no any switch so I assume that I can use only El34s. But here "chgo skinny" says He managed to put 6L6s into this amp, so there's some hope ;)

Hi, I have emailed this problem to Randall but I think I'll post it here anyway. I have accidentally destroyed one of my power tubes (or I think I did it ) by turning the bias pot to far clockwise. The amp started to play at half of its power. It still sounds OK but it's very quiet. - Can I...

Well, I own RH50T with R412CX cab and for me it rocks, but i didn't have the oportunity to compare it to any other all tube amps. Also, I aked Randall for biasing instructions but they didnt send me anything so far. I just wish that this amp had a little more 'recto' sound ;)

Hi, I have one problem: the input level of the amp is much to high, both "low" and "high" impedacy inputs produces slightly distorted sound on "clean" channel, with boost enabled its becomes almos comlete overdriven. Of course the same is about overdrive channels, the amp has much to much gain...