Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Egnater / Randall Modular Amps
Can RT2/50 power a 7-pin MIDI pedal?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Jaded Faith" data-source="post: 145598" data-attributes="member: 1068"><p>I just dug up the MIDI schematic from my library and the RT 2/50 is indeed able to supply a 9V phantom supply via 7-pin cables. If yours is not doing so, it's either an issue with the cable or the fuse on the MIDI PCB itself is blown and needs to be replaced. Test the cable with a simple replacement for another or a continuity tester on each pin.</p><p></p><p>These are typically solder-stye fuses that you may mistake for a capacitor. If you are not experienced with soldering on fragile PCB's (the MIDI PCB is fragile, has potential to be damaged via heat or static electricity and is a good bit harder to work on than a module is), take it to a tech or email me for help. The component is F1 on the PCB.</p><p></p><p>If the pedal LED's light up and you just aren't getting any changes happening the pedal and unit are likely just on different MIDI channels.</p><p></p><p>Good luck!</p><p></p><p>Rob</p></blockquote><p></p>
[QUOTE="Jaded Faith, post: 145598, member: 1068"] I just dug up the MIDI schematic from my library and the RT 2/50 is indeed able to supply a 9V phantom supply via 7-pin cables. If yours is not doing so, it's either an issue with the cable or the fuse on the MIDI PCB itself is blown and needs to be replaced. Test the cable with a simple replacement for another or a continuity tester on each pin. These are typically solder-stye fuses that you may mistake for a capacitor. If you are not experienced with soldering on fragile PCB's (the MIDI PCB is fragile, has potential to be damaged via heat or static electricity and is a good bit harder to work on than a module is), take it to a tech or email me for help. The component is F1 on the PCB. If the pedal LED's light up and you just aren't getting any changes happening the pedal and unit are likely just on different MIDI channels. Good luck! Rob [/QUOTE]
Verification
Post reply
Modular Amps
Egnater / Randall Modular Amps
Can RT2/50 power a 7-pin MIDI pedal?
Top