Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Egnater / Randall Modular Amps
Need amp/cab configuration help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="JKD" data-source="post: 66947" data-attributes="member: 879"><p>If you are plugging two cabs into the RM100 Main and Extension then you should follow the formula for impedance added in parallel.</p><p></p><p>1/LoadA +1/LoadB = 1/Load</p><p></p><p>In your case 1/16+1/16 = 1/8 set the amp head to 8Ohms</p><p></p><p>You should not use 4 Ohms because 1/4+1/4=1/2 is only a 2Ohm load, which is too low.</p></blockquote><p></p>
[QUOTE="JKD, post: 66947, member: 879"] If you are plugging two cabs into the RM100 Main and Extension then you should follow the formula for impedance added in parallel. 1/LoadA +1/LoadB = 1/Load In your case 1/16+1/16 = 1/8 set the amp head to 8Ohms You should not use 4 Ohms because 1/4+1/4=1/2 is only a 2Ohm load, which is too low. [/QUOTE]
Verification
Post reply
Modular Amps
Egnater / Randall Modular Amps
Need amp/cab configuration help
Top