Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Synergy Amps & Modules
Question about using just #1 and #4 tubes in RM100KH...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MegaGoo" data-source="post: 62426" data-attributes="member: 2293"><p>so you CAN safely just remove the fuses for tubes you dont want to run? this would be much easier than pulling tubes for quick tonal comparisons</p><p></p><p>impedance question: (when using all 4 tubes) you obviously set the ohm switch to whatever the load is on the cabinet. but when you have an additional load on the "extension speaker" output, how do you compensate? for instance on my Vetta, i believe if you plug in left mono 8 ohms, the switch is 8 ohms. if you plug in another 8 ohm load on the other side, it stays 8 ohms. but from the sound of this thread, if you put an 8 ohm load on the main, and an 8 on the extension, you need to switch it to 4</p><p></p><p>the manual is not clear on this...</p></blockquote><p></p>
[QUOTE="MegaGoo, post: 62426, member: 2293"] so you CAN safely just remove the fuses for tubes you dont want to run? this would be much easier than pulling tubes for quick tonal comparisons impedance question: (when using all 4 tubes) you obviously set the ohm switch to whatever the load is on the cabinet. but when you have an additional load on the "extension speaker" output, how do you compensate? for instance on my Vetta, i believe if you plug in left mono 8 ohms, the switch is 8 ohms. if you plug in another 8 ohm load on the other side, it stays 8 ohms. but from the sound of this thread, if you put an 8 ohm load on the main, and an 8 on the extension, you need to switch it to 4 the manual is not clear on this... [/QUOTE]
Verification
Post reply
Modular Amps
Synergy Amps & Modules
Question about using just #1 and #4 tubes in RM100KH...
Top