Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Synergy Amps & Modules
Question on R5 midi controller and Syn 2
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="gaboocho" data-source="post: 157628" data-attributes="member: 3828"><p>Yes, directions are in the SYN-2 manual.</p><p></p><p>Connecting Multiple SYN2s</p><p>Follow the steps below to combine 2 or more SYN2 units. In this connection scheme the first SYN2 in the</p><p>signal chain is called the “Master” and the second SYN2 is the called the “Slave”.</p><p>- Connect your instrument to the Input of the Master unit.</p><p>- Run a cable from the "TO AMP IN" of the Master unit to the "INST. IN" on the rear panel of the Slave unit.</p><p>- Connect the main output L/MONO of the Slave unit to the "FROM AMP FX SEND" of the Master unit.</p><p>- Use the MAIN OUT(s) or the DI output(s) of the MASTER unit to connect to your power amp / monitors.</p><p>- Program the Slave with the Master in Bypass Mode.</p><p>Note - When using the input on the front panel, the "INST IN" on the back panel is disengaged.</p><p>The same procedure is recommended for adding a third, fourth etc. unit to the system</p><p>For most systems, it’s recommended that you set your SYN2s to the same MIDI channel. You can follow the</p><p>programming instructions above, repeating the steps for each SYN2. When you want to access the second</p><p>SYN2, make sure that the first SYN2 is set to bypass.</p></blockquote><p></p>
[QUOTE="gaboocho, post: 157628, member: 3828"] Yes, directions are in the SYN-2 manual. Connecting Multiple SYN2s Follow the steps below to combine 2 or more SYN2 units. In this connection scheme the first SYN2 in the signal chain is called the “Master” and the second SYN2 is the called the “Slave”. - Connect your instrument to the Input of the Master unit. - Run a cable from the "TO AMP IN" of the Master unit to the "INST. IN" on the rear panel of the Slave unit. - Connect the main output L/MONO of the Slave unit to the "FROM AMP FX SEND" of the Master unit. - Use the MAIN OUT(s) or the DI output(s) of the MASTER unit to connect to your power amp / monitors. - Program the Slave with the Master in Bypass Mode. Note - When using the input on the front panel, the "INST IN" on the back panel is disengaged. The same procedure is recommended for adding a third, fourth etc. unit to the system For most systems, it’s recommended that you set your SYN2s to the same MIDI channel. You can follow the programming instructions above, repeating the steps for each SYN2. When you want to access the second SYN2, make sure that the first SYN2 is set to bypass. [/QUOTE]
Verification
Post reply
Modular Amps
Synergy Amps & Modules
Question on R5 midi controller and Syn 2
Top