Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Synergy Amps & Modules
Synergy VS Egnater : cathode switch
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MarcoR" data-source="post: 155518" data-attributes="member: 961"><p>Yes, when I got the DS module, the switch was set to position 1. The module sounded good but using it on the lower side of gain, I was wanting a deeper tone especially on the A channel where I was trying to get a clean tone. </p><p></p><p>I switched it to position 2 and it was perfect. Looking at the manual, it stated that position 2 was the preferred setting. So apparently they are not necessarily setting the switches to what is recommended in the manual even though it states " The modules will come preset to the designers preferred setting" . It would probably be a good idea to check that when getting a new module.</p><p></p><p>I would say this is a big improvement on the old MTS as it's one less compromise the platform needs to accommodate all the various preamp circuits. It also really helps to tailor the sound to the the host amp you are using and other gear as well. Not to mention balancing two different modules...</p></blockquote><p></p>
[QUOTE="MarcoR, post: 155518, member: 961"] Yes, when I got the DS module, the switch was set to position 1. The module sounded good but using it on the lower side of gain, I was wanting a deeper tone especially on the A channel where I was trying to get a clean tone. I switched it to position 2 and it was perfect. Looking at the manual, it stated that position 2 was the preferred setting. So apparently they are not necessarily setting the switches to what is recommended in the manual even though it states " The modules will come preset to the designers preferred setting" . It would probably be a good idea to check that when getting a new module. I would say this is a big improvement on the old MTS as it's one less compromise the platform needs to accommodate all the various preamp circuits. It also really helps to tailor the sound to the the host amp you are using and other gear as well. Not to mention balancing two different modules... [/QUOTE]
Verification
Post reply
Modular Amps
Synergy Amps & Modules
Synergy VS Egnater : cathode switch
Top