another bias question?

Synergy/MTS Forum

Help Support Synergy/MTS Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
D

drsakky

Well-known member
Joined
Jun 20, 2011
Messages
48
Reaction score
0
Location
Australia
Hi,

I was hoping someone here can tell me how long should your amp be powered up before you check or set your bias. Should you leave it on for a hr to warm right up or should you do it after like 10 mins ?

Thanks
 
A few minutes should be fine, an hour is way over kill. The main thin I'd after you bias them give them a few minutes to adjust and check them again - after 5 minutes or so you have need to do a slight bias adjustment.
 

Share this page

Similar threads

W
Syn-50: noise when turning-off
Replies
4
Views
519
wahlsn
W
dgadwa
My amp shelf + SYN-1. Let's see yours!
Replies
0
Views
1K
dgadwa
dgadwa
K
RANDALL RM100 POPPING FOUND FUSES, HELP ID FUSES?
Replies
0
Views
505
Kudogg
K
jweinke74@gmail.com
SYNERGY IICP-RANDALL RM50 COMBO
Replies
6
Views
785
[email protected]
jweinke74@gmail.com
C
RM100 Mains Fuse / Mains Input Connector/Transformer Wiring
Replies
2
Views
1K
j4q0
J

Latest posts

Top