Bi-Color LEDs

Synergy/MTS Forum

Help Support Synergy/MTS Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
M

Mattfig

Well-known member
Joined
Jun 22, 2010
Messages
5,688
Reaction score
1
Location
Hurtling through space on a wet rock.
Hey guys,

Just ordered a bunch of funky LEDs and the bi-colored ones confuse me...They have the standard two leads but what do I need to do to make it cycle colors between red and green? I was under the impression that it was a changing pattern but I guess I need to tie a resistor in there somewhere....FWIW, it's on a Top Boost module...


Any help is appreciated...
 
Matt,

I orderd some the green/red LED's from mouser for a couple new mods I am doing but mine have 3 terminals on them. Where did you buy them? Is there a spec sheet for them, that should make it pretty easy to tell.
 
If it only has two leads then when you switch the polarity, reverse + and -, it'll switch colors. Remember to use resistors in series with it.
 

Share this page

Similar threads

C
RM100 Problem - Crackle, Pop, Blown Power Tube Fuse - Help!
Replies
7
Views
5K
Corium_AZ
C
E
Adding dual module support to single module amps
Replies
4
Views
11K
User32
U
D
Sacred Groove Fisch+ TRADED
Replies
0
Views
491
Disciple
D
D
SD Judge and Jury Prototype for sale
Replies
4
Views
780
Disciple
D
C
Module Bag results!!!
2
Replies
33
Views
9K
seanh303
S

Latest posts

Top