KonkeyDong
Active member
What are you guys using for pedalboards, gig-wise. I was considering those softer ones from gator, but I'm leaning towards a powered hardcase type.
Pedal-boards
- Thread starter KonkeyDong
- Start date
Help Support Synergy/MTS Forum:
I use this one. It is big and tough and alows you too run 2 rigs from it, sickness.
they make an even better one with cable tester and all kindsa bells on it but this one does the job so well for me.
http://www.skbcases.com/music/products/proddetail.php?id=32&c=85&o=&s=75#
they make an even better one with cable tester and all kindsa bells on it but this one does the job so well for me.
http://www.skbcases.com/music/products/proddetail.php?id=32&c=85&o=&s=75#
johnodge
Well-known member
I have a big custom one, I'll take a pic of it tonight....
insightibanez
Well-known member
I use a cheap one I bought off ebay for around $40.00 Its powered, in a soft case. I dont do much gigging but if I did I would bust out some cash and invest in a hardcase. The Hunter has a nice one, I would recommend getting.
Since this thread is going again...
I use a pedaltrain. I have the softshell case with it and have had no problems. I gig 2-3 nights a week. If i had to, i would buy one again in a heartbeat.
Dont by the gater g-bus p/s. Horrible. It doesnt have isolated outputs so it makes all of your pedals humm and buzz. Plus, no right angle connectors.
I use a pedaltrain. I have the softshell case with it and have had no problems. I gig 2-3 nights a week. If i had to, i would buy one again in a heartbeat.
Dont by the gater g-bus p/s. Horrible. It doesnt have isolated outputs so it makes all of your pedals humm and buzz. Plus, no right angle connectors.
trendkill1168
Well-known member
I made my own from a big piece of plywood and then covered it with industrial strength velcro from Home Depot. Power it with an MXR DC brick and it works like a charm.
