I recently obtained a used Egnater MTS module (SL) but don’t have an interface such as RM4, SYN1, SYN2 to install it to. I’m now thinking of building a very basic single-module interface (with one module slot, a power input, an input jack, an output jack) so that it can work with my module as an independent preamp unit. I should be able to obtain a slot part for accepting the module’s connector. Would it be enough, if I also get some kind of chassis, a DC jack, two phone jacks (for audio input and output), a proper power supply – and wire them correctly, or do I need more? I was assuming an MTC module to be a preamp without a power input or audio input/out, but is my assumption correct?? I’m new to this forum and would appreciate any help, tips, etc. anyone could kindly offer me.
I think that the post below gives me enough information on how to connect each component. I also see that the module requires 18V DC, but I don’t know how much ampere it requires. Could anyone help me?
http://mtsforum.grailtone.com/viewtopic.php?t=20650&highlight=schematics+module+power
Thanks!
I think that the post below gives me enough information on how to connect each component. I also see that the module requires 18V DC, but I don’t know how much ampere it requires. Could anyone help me?
http://mtsforum.grailtone.com/viewtopic.php?t=20650&highlight=schematics+module+power
Thanks!