RM100 issue

Synergy/MTS Forum

Help Support Synergy/MTS Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Mattallica

Well-known member
Joined
Nov 15, 2017
Messages
69
Reaction score
0
Guys, i did a dumb thing.

I popped the tube shield off of the fx loop tube while the amp was running and it cut out.

The power section is now not working.

Power tubes look fine, no bang or smoke happened.
The failure leds are not illuminated.

Pre-amp is fine.

I've checked all the fuses (not just the power tube ones) and they are all intact.

What did i break?
 
Did you try replacing the loop tube? It's a logical point of failure given where your signal is broken and your actions.
 
Hi Rob,

Yes i've tried replacing the loop tube, and the PI tube as well, with no luck.

I'm going to check the sockets this weekend, fingers crossed for something easily identifiable.
 
Check the socket pins. Try re-tensioning them and possibly reflow the solder joints on V2. I just fixed a Renegade this morning with the same problem. It's back to life now.
 
Top