Hi guys
I just realized during a rehearsal I was running my RM22 into my Marshall stereo cab on 4 ohms (the amp specifies 8/16 ohm)
After realizing , I quickly switched to the 16 ohm input and found it sounded quite a bit better in the 4 ohms ( tighter , clearer less compressed)
My question is can the RM22 handle running at 4 ohm or as I suspect this will blow up the amp and dont do it ? :x
I just realized during a rehearsal I was running my RM22 into my Marshall stereo cab on 4 ohms (the amp specifies 8/16 ohm)
After realizing , I quickly switched to the 16 ohm input and found it sounded quite a bit better in the 4 ohms ( tighter , clearer less compressed)
My question is can the RM22 handle running at 4 ohm or as I suspect this will blow up the amp and dont do it ? :x