Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Rigs & Tones
AMP IS ON THE FRITZ PLEASE HELP.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="TheHunter" data-source="post: 22620" data-attributes="member: 1090"><p>So i left the amp on all night the night before last, i had left the Ultra Lead out of channel one and switched the amp to channel 3 to see if it would still do it, and with success it worked. The amp switched itself to channel 1 or rather the channel without a module. So i unplugged the amp, did a bias check to make sure the tubes were performing correctly set it all back up and nothing no issues and i played for about 2 hours last night and it was doing fine i even put the Ultra Lead back in and it was working fine. </p><p></p><p>Now my issue is when i turn the amp from PLAY to Standby it pops and it makes my teeth grind. Im afraid it may have an impact on the speakers one day, is this true? Does anyone else experience this popping when putting the amp into standby. Ive noticed that if i do it slowly its not as bad but still pops a bit.</p><p></p><p>Thanks George for your comments.</p></blockquote><p></p>
[QUOTE="TheHunter, post: 22620, member: 1090"] So i left the amp on all night the night before last, i had left the Ultra Lead out of channel one and switched the amp to channel 3 to see if it would still do it, and with success it worked. The amp switched itself to channel 1 or rather the channel without a module. So i unplugged the amp, did a bias check to make sure the tubes were performing correctly set it all back up and nothing no issues and i played for about 2 hours last night and it was doing fine i even put the Ultra Lead back in and it was working fine. Now my issue is when i turn the amp from PLAY to Standby it pops and it makes my teeth grind. Im afraid it may have an impact on the speakers one day, is this true? Does anyone else experience this popping when putting the amp into standby. Ive noticed that if i do it slowly its not as bad but still pops a bit. Thanks George for your comments. [/QUOTE]
Verification
Post reply
Modular Amps
Rigs & Tones
AMP IS ON THE FRITZ PLEASE HELP.
Top