roodyrocker
Well-known member
I'm wiring up my pedal board and was wondering about the best way to run my effects pedals with the RM100. Right now I have it this way:
Guitar output>Fulltone Wah>Fulltone OCD (distortion pedal)>BBE Sonic Maximizer pedal>Rocktron Hush pedal>RM100 input. Then I have my Fulltone ChoralFlange, Guyatone mini delay, and Holy Grail Reverb going through the effects loop. Is this the way you guys would run it? I know the manual says the loops are intended for rack effects rather than pedals, should I leave the time based effects pedals in the loop? Would I be better off moving the other pedals to the series loop? I have not lost volume by putting the pedals in the loop as the manual says may happen with some floor/tabletop effects so that hasn't been an issue. Just looking for cleanest way to run these effects. BTW, I don't use all these effects at once all the time, I just use what I need for particular songs, my band does mainly 80's hard rock covers.
Thanks.
Guitar output>Fulltone Wah>Fulltone OCD (distortion pedal)>BBE Sonic Maximizer pedal>Rocktron Hush pedal>RM100 input. Then I have my Fulltone ChoralFlange, Guyatone mini delay, and Holy Grail Reverb going through the effects loop. Is this the way you guys would run it? I know the manual says the loops are intended for rack effects rather than pedals, should I leave the time based effects pedals in the loop? Would I be better off moving the other pedals to the series loop? I have not lost volume by putting the pedals in the loop as the manual says may happen with some floor/tabletop effects so that hasn't been an issue. Just looking for cleanest way to run these effects. BTW, I don't use all these effects at once all the time, I just use what I need for particular songs, my band does mainly 80's hard rock covers.
Thanks.